Scan Time Limit Exceeded

Hello @raghuvirgupta and thanks for reaching out to us!

Can you send a diagnostic report to wftest @ wordfence . com? You can find the link to do so at the top of the Wordfence Tools > Diagnostics page. Then click on “Send Report by Email”. Please add your forum username where indicated and respond here after you have sent it.

Thanks!

Sent please check.

Thanks for sending that @raghuvirgupta

Can you navigate to your Wordfence > All Options > Scan Options > Performance Options and make sure the following are set as such:

Time limit that a scan can run in seconds = 0
How much memory should Wordfence request when scanning = 256
Maximum execution time for each scan stage = 20

Then head back over to the Scan page and CANCEL any current scans and start a NEW one.

Let me know what you find!

Thanks!

How much memory should Wordfence request when scanning = 256
Maximum execution time for each scan stage = 20

This I have already set… Time limit that a scan can run in seconds was zero but then I increased it.

I would like to see where the scan is hanging. Could you do the following for me?

• In the “Debugging Options” section check the circle “Enable debugging mode”
• Click to “Save Changes”.
• Start a new scan
• Copy the last 20 lines from the Log (click the “Show Log” link) or so of the activity log once the scan finishes and paste them in the post.

Thanks!