New install just shows a “0”

  • Resolved Mike

    (@ukstocky)


    4 years, 3 months ago

    Just installed and activated the plugin for the first time.

    On the “Sites / Start” screen after a new installation and it briefly flashes up the “Loading…may take a while for huge websites” message and then just shows a “0”.

    Any ideas?

    Side note: I used the “report issue” button but it doesn’t seem to send the message, just spools for a few seconds and then the submit button reappears.

Viewing 3 replies - 1 through 3 (of 3 total)
  • Plugin Contributor alaasalama

    (@alaasalama)

    Hi Mike!
    There must be a plugin conflict causing this issue, I suggest opening the browser console while being on this page (you can click on CTRL+SHIFT+J while using Chrome browser), then check if there is any JS error being reported there, sharing a screenshot of it would be helpful.

    Thanks,
    Alaa

    Thread Starter Mike

    (@ukstocky)

    If I inspect the page there are no errors in the console, but sometimes on messages like these (but not always, I refreshed a few times):

    [Violation] Forced reflow while executing JavaScript took 139ms
    [Violation] Forced reflow while executing JavaScript took 51ms

    Screenshots (not sure the etiquette for this, hopefully these are okay):
    This flashes up – https://pasteboard.co/JCVNZ3K.jpg
    Then this remains – https://pasteboard.co/JCVOskP.jpg

    Thanks,
    Mike

    Plugin Contributor alaasalama

    (@alaasalama)

    Hi Mike!
    Thanks for sharing these details!

    Please open a support ticket via this form:
    https://wp-staging.com/support/

    And I’ll follow up your conversation from there.

    Thanks,
    Alaa

Viewing 3 replies - 1 through 3 (of 3 total)
  • The topic ‘New install just shows a “0”’ is closed to new replies.