Display not rendering, but…

  • Resolved Curt44319

    (@curt44319)


    10 years, 12 months ago

    …I have no good data ( keep going ) to offer, except that it worked in 5.2.16 and is broken in 5.2.21. ( my busy life )
    In order to provide something, I would like to incrementally upgrade version by version to find where/when/what changed. The problem may well not be with the plugin at all.
    How do I get versions 5.2.17, 5.2.18, 5.2.19, etc. so that I can find when what broke ?

    https://www.ads-software.com/plugins/wp-photo-album-plus/

Viewing 4 replies - 1 through 4 (of 4 total)
  • Plugin Author Jacob N. Breetvelt

    (@opajaap)

    5.2.19 and 5.2.20 are available here: https://www.ads-software.com/plugins/wp-photo-album-plus/developers/

    You need to instal ‘manually’ ( download, unpack, ftp ) and run Setup (Table VIII-A1) after each manually installed version.

    If you really need other versions, pls tell me, i can provide them but it takes work to do.

    Sure you have no funny caching plugin active or other ‘intelligent’ speed up thing?

    Thread Starter Curt44319

    (@curt44319)

    No funny caching that I know of.
    I just copy the backup of 5.2.16 over 5.2.21 and it works.
    Copy 5.2.21 over 5.2.16 and it doesn’t.
    Viewing the rendered page source says it’s there, but it doesn’t appear in at least two browsers.
    My intent is an incremental upgrade, and find the difference in rendered page source. Then, start troubleshooting. ??

    As usual, thank you for a more than prompt response.

    Thread Starter Curt44319

    (@curt44319)

    5.2.19 works fine.
    5.2.20 also works fine. ( the link appears to be a whole archive of various trunks, but I found what I needed to construct 5.2.20 )
    Hmmm….
    Now, 5.2.21 also works fine !

    Probably, I’d skipped a version somewhere during previous upgrades.
    It’s the only thing I can think….

    Let’s call this one resolved for now ?

    Plugin Author Jacob N. Breetvelt

    (@opajaap)

    I am glad it is resolved. To remember: If an update might not be complete you can always run the Setup proc in Table VIII-A1, this should fix this kind of problems. Thanx for your reports.

Viewing 4 replies - 1 through 4 (of 4 total)
  • The topic ‘Display not rendering, but…’ is closed to new replies.