Problem after install. Site without access

  • Hello,

    I’m working on a local install on Mac with AMPPS.
    Mac under High Sierra 10.13
    Ampps (3,8). I tried 3.9 with same issue.

    I created a mysite.localhost on Amppps. It works fine.
    I installed a new install of WordPress. As usual I get the final message at the end.

    mysite.localhost for the site.
    mysite.localhost/wp-admin/ for the admin login.

    However, mynewsite.localhost resolves to localhost. And when I then have to click the link to mynewsite.localhost, it resolve to mynewsite.localhost/mynewsite.localhost.

    Finaly, the last url display a wordpress welcome page, but without any pict or css. I could show you a screenshot to give you an idea.

    Screenshot

    Could you help me ?
    Thank you.

Viewing 5 replies - 1 through 5 (of 5 total)
  • Richard

    (@richardcoffee)

    I believe I may be able to help, but you may not be happy with my advice, which is this:

    Wipe out what you have and start over. This time do not preface the url, keep it as simply localhost. In Settings->General give your url as https://localhost.

    I run this setup on a LAMP stack on my computer. I have no experience with Ampps, so this may not work for you, although I believe it should.

    Good Luck!

    Thread Starter bugsfunny

    (@bugsfunny)

    Thank your Richard for your answer.

    I’m not sure to understand when you write “keep it as simple localhost”: I have “localhost”.

    https://localhost display a page with all my local web sites are listed, as link.

    mysite1.localhost
    mysite2.localhost
    …
    .

    The old one are working nice. Anyway, some are not working as I describe in my precedent post. And if I create a new website install, the result is the same as those are not working. (screenshot).

    I tried to scratch everything and install again Ampps but no change…
    May be I have a wrong conf file somewhere but I can’t understand where.

    Thread Starter bugsfunny

    (@bugsfunny)

    I’ve forgotten to precise I check if the database was correctly connected and it’s ok. The data base is well connected.

    Richard

    (@richardcoffee)

    Ahh, I didn’t realize you have multiple local sites. I can’t help with that. Hopefully, someone else will chime in here. Sorry, I hope you get the issue solved.

    Thread Starter bugsfunny

    (@bugsfunny)

    Thank you Richard.

    Nobody else to help me ?

Viewing 5 replies - 1 through 5 (of 5 total)
  • The topic ‘Problem after install. Site without access’ is closed to new replies.