Use the .Cyclone slider 2 as header

Visited the installation on your site, looks like you got the slider in there at the header, it looks good. But it is acting a little strange. The slider took a while to load. Then, it auto advanced a little roughly. I started clicking the right and left arrows and parallel blue dotted lines appeared between them. Then the auto advance froze. I got it to restart by clicking the right arrow; and the blue dotted lines went away.

Here is a screen shot of the slider with blue dotted lines…

Thank you,
Kris

Hello,
The slider you see on my test page in not a Cyclone 2 :-). After a lot of experiments without results and with no help from the cyclone support i tried the WP “Responsive slider”. I am sure you see this slider. When I tested Cyclone slider he stay on the left and not with full width. If you know how to achieve a full width of the ‘Cyclone 2 slider” on the header, please share with me?!

Ah, I see.
Well, I am having luck with Cyclone 2 in sidebars, works well there.
But it is only 200-300px wide there, so cannot reproduce your situation.
I wish you well. Maybe someone will follow up on this…

Hello guys,

@tomas173 – That full width feature is not currently supported. What your looking for is something in the line of supersized but instead of a full width background, its a full width header. You might need to do a bit of googling for that.

@krisargent – Good to hear it works well for you and thanks for helping out. ??

Best regards